Victorian Transmission System
The Victorian Transmission System is a 50 Hz model of the transmission grid of Victoria, Australia, with 125 buses from 500 kV down to generator terminals, 11 synchronous generating units (8 thermal on TGOV1 governors, 3 hydro on HYGOV, each with an ENTSOE_simp or ST1A exciter), the interconnectors to New South Wales and South Australia modelled as synchronous machines, and 23 wind and solar plants on the WT4 converter model. It was built by J. Vorwerk to study fast frequency response in a system with high renewable and electrified-heat shares. Beside one ready-to-run operating point, it carries the scripts and scenario data that generate the power flow and dynamic data for any half-hour of five study days at three levels of heating electrification.
Repository: SPS-L/stepss-VICSystem, a fork of the author’s JohannaVorwerk/VICSystem carrying the changes it needs to run with current STEPSS.
Quick Start
Section titled “Quick Start”import stepss
case = stepss.cfg()case.addData('pyRdat_ss.dat') # network and power-flow solutioncase.addData('pyRdat_dyn.dat') # machines, exciters, governors, WT4 plantscase.addData('SOLVEROPTIONS.dat') # solver settingscase.addDst('trip_SM35G1.dst') # loss of a 500 MW unit at t = 0.5 s, 20 s horizoncase.addObs('obs.dat') # observables to record
sim = stepss.sim()sim.execSim(case)nothing.dst runs the same 20 s with no disturbance, and VICSystem.cfg opens the trip in the STEPSS desktop application. TNSingleSim.py runs the full example study: it trips the unit, plots generator, reserve and wind-farm responses, and estimates the kinetic energy supplied by generators and interconnectors.
Other Operating Points
Section titled “Other Operating Points”The shipped data is one half-hour of one study day. GenerateOPs/TNLoadFlow.py solves the power flow of every half-hour of a chosen day and electrification level with Helios, and GenerateOPs/TNDynamicData.py turns one of those solutions into the two data files above. Both are run from inside GenerateOPs/; the repository README lists the days, levels and steps.
Download
Section titled “Download”The test system files are available in the stepss-VICSystem repository.
Citation
Section titled “Citation”If you use this test system in your research, please cite the publications it was developed for:
J. Vorwerk, Integration of Fast Demand Response into Renewable Power Systems, PhD thesis, ETH Zurich, doi:10.3929/ethz-b-000643071.
J. Vorwerk, I. Saedi, P. Mancarella, G. Hug, “Electrifying thermal loads vs. installing batteries: A case study on fast frequency resource potentials of the Victorian power system”, Electric Power Systems Research, vol. 235, 110622, 2024, doi:10.1016/j.epsr.2024.110622.
See Also
Section titled “See Also”- Test Systems, the other benchmark networks
- Static Exciters, the
ENTSOE_simpandST1Aexciters used here - IEEE Governors, the
TGOV1andHYGOVgovernors - WECC Models, the
WT4converter plants - Power Flow, the Helios input format the operating-point scripts write